Signal routing
Last 120 seconds
Operating mode
How your amplifier receives the music and who controls the volume. Pick this first.
—
—Rear optical output
What the second optical output carries.
Where navigation and phone voices are heard. Modes 2 and 3 always use the center speaker.
Nav voice output
Phone voice output
The iDrive generation (Auto finds it from the car) and the speed unit shown in the car.
Head unit
Speed unit
REM OUT control
When the REM OUT wire switches your amplifier on and off (boards with the output).
Amp remote
KLAR-NET talks to a Helix / Match amplifier over its remote-control port: volume, sound setups and inputs. Used in Modes 2, 3 and Auto. In Mode 3 the steering wheel controls the amp's Bluetooth: press next = next track, hold next for half a second = play / pause, prev = previous track.
Using the car's volume freezes the Conductor; press and hold the knob to wake it.
Set at every start-up. In DSP PC-Tool set all four Conductor volumes to 60 dB range, 1 dB steps.
Set at every start-up, in 0.5 dB steps like the Director.
Amplifier Bluetooth
Track control for the amplifier's own Bluetooth (Mode 3 music source).
The amplifier's own Bluetooth (Mode 3 music source): connect or pair a phone, and what it is playing.
Track buttons work while Mode 3 is live. In the car: steering wheel next = next track, hold half a second = play / pause.
Levels
Changes apply immediately and are stored on the board after half a second.Warnings
Parking
Car sounds
Voices
Center speaker
Music & amplifier
Test sounds
Events
Which sound plays for which car event.
Each event plays the sound assigned to it. Drag a sound from the list onto an event, or click an event and then a sound. ▶ plays the event on the board. Empty slots are filled from the Sniffer when a new car event is found.
Sounds
The sounds available on the board.
Built-in sounds, plus the sounds of the pack loaded on the board. To load a pack you received (KLAR-NET_SOUNDS_xxx.ksp), pick the file and press Load; it takes about half a minute and the car sounds are silent meanwhile.
Sniffer locked
The sniffer is a service tool. Read the challenge number to EuroLab support, type the unlock code you get back, and the sniffer opens until the car goes to sleep.
| ID | count | period | data | Δ mark | last | event |
|---|
Press Start, do one thing in the car (open a door, fasten the belt…), press Mark right before it. The IDs box limits the table to a range (100-1FF) or a list (12F, 2F0) — type it before Start or any time later. Bytes that changed after the mark are shown orange; counters and checksums that change all the time are greyed. Click the row to make it a candidate event.
Learn a new event
Expert: pattern editor
Event log
Update firmware
Install a newer KLAR-NET firmware you received.
Choose the update file you received (KLAR-NET_FWxxx.enc), then press Start update. The update takes about a minute. Keep the USB cable connected and do not close this page until it says "Updated".
Settings
The buttons at the top of the page work on every tab: Read from board reloads what the board has, Save to board stores the current settings permanently, Save to file / Load from file keep a copy on this computer or move the settings to another board, Reboot board restarts it.